Cisco 300-370 Interactive Bootcamp 2021

NEW QUESTION 1
Refer to the exhibit.
Which option prevents the AP from completing the DTLS join process?

• A. The SSC is not authorized.
• B. The root CA is missing on the WLC
• C. The WLC has the incorrect date.
• D. An intermediary CA is missing on the WL

Answer: A

NEW QUESTION 2
DRAG DROP
Drag and drop the IP address range on the left onto the specific purpose for multicast groups on the right. Not all options are used.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 3
An engineer has configured 802 1x for the network and all but one of the APs are passing authentication. Which configuration is causing the failure?

• A. The AP has override global credentials checked.
• B. The switch AAA credentials do not match what is configured on ISE.
• C. The controller 802 1x supplicant credentials do not match what is configured on ISE
• D. EAP-FAST is configured on ISE for this A

Answer: A

NEW QUESTION 4
The AP is unable to join the controller. What is the cause of this error? Refer to the exhibit.

• A. The controller code version is lower than the code of the AP attempting to join.
• B. AP code is not the same as the controller and must download firmware.
• C. AP model % not compatible with the controller code version.
• D. The AP is riot conjured in the controller auth-list of acceptable AP

Answer: C

NEW QUESTION 5
Access points ate deployed in an office building and users report that the real-time communications quality of experience is poor when users walk between the elevators The elevators are a heavy metallic obstacle, and AP 3 was installed to cover the elevator area, which AP t and AP 2 signal does not reach Communications are captured for a user walking from point A to point C. and it is observed that the user iPhone device suddenly scans all bands and then roams from AP I to AP 3 somewhere between points B and C WLAN is set to 5 GHz only. Open, default rate configuration. Which action improves the real-time application quality of experience in this area?
Refer to the exhibit.

• A. Enable 802 11v on the WLAN
• B. Enable 802 11r on the WLAN
• C. Enable 802 11k on the WLAN
• D. Move AP 2 to point B

Answer: B

NEW QUESTION 6
A WLAN engineer has just completed a wireless network installation using Cisco 2700 series access points. After checking the WLC, it seems that the APs are running in medium power. What effect will this have in the APs?

• A. Due to insufficient power, the access points are not broadcasting any Wireless networks.
• B. Due to insufficient power, only the 2 4 GHz radio is up.
• C. Due to insufficient power the access points have dynamically shifted from 3x4 to 3x3.
• D. Due to insufficient power the access points have dynamically shifted from 4x4 to 3x3.

Answer: C

NEW QUESTION 7
A Wireless LAN Cisco engineer is troubleshooting 802. 11ac WLAN at customer site Doe to interferences with neighboring 802 11n networks the engineer must determine the current primary secondary channel allocation to enhance the current configuration. Channel 60 has been chosen by the customer as primary 20 MHz channel. Which combination determines the resulting primary 40 MHz and primary 80 MHZ channels?

• A. primary 40 MHz channel 62, primary 80 MM: channel 58
• B. primary 40 MHz channel 54, primary 80 MHz channel 58
• C. primary 40 MHz channel 64, primary 80 MHz channel 60
• D. primary 40 MHz channel 60, primary 80 MHz channel 56

Answer: A

NEW QUESTION 8
An engineer wants to run the Voice Audit tool in PI and wants to be able to verify: that clients will be capable of having static IPs whether or not Call Admission Control is enabled
Which two rules field descriptions must be checked in the report? (Choose two.)

• A. DHCP assignment
• B. CAC: max bandwidth
• C. ACM
• D. DTPC
• E. load-based CAC

Answer: AE

Explanation:
/Reference:
Reference: https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3- 2/reference/guide/
pi_ref.pdf

NEW QUESTION 9
Which visual cue accurately describes a characteristic of the zone of impact displayed in Cisco Prime Infrastructure?

• A. The closer the cirlce is to blue, the more localized the impact is.
• B. The smaller the circle, the more localized the impact is.
• C. The larger the circle, the more severe the impact is.
• D. The more translucent the circle is, the more localized the impact i

Answer: B

NEW QUESTION 10
From the WLC GUI, which RRM setting do you configure to avoid non-Wi-Fi interference?

• A. Coverage
• B. TPC
• C. General
• D. DCA

Answer: D

NEW QUESTION 11
Some users are experiencing inconsistent performance on their mobile devices as they move throughout the building when browsing the Internet. Which feature provides a more consistent user experiences?

• A. low RSSI check
• B. 802.11r
• C. RX-SOP
• D. optimized roaming

Answer: A

NEW QUESTION 12
Which statement about the usage of the debug command in a Cisco Unified Wireless Network is true?

• A. Debug is enabled until manual shut off.
• B. Debug is a message logging severity 7.
• C. Debug is a restricted command and is not available in the AP CLI.
• D. Debug is available on the WLC serial console and web interfac

Answer: B

NEW QUESTION 13
An engineer is attempting to resolve wireless channel overlap issues in the 2.4 GHz network. Which network change reduces channel overlap?

• A. Shut down 802.11b/g/n radios.
• B. Enable 40 MHz channel bonding on 802.11b/g/n.
• C. Enable 802.11b data rates.
• D. Enable all 802.11b/g/n channel

Answer: D

NEW QUESTION 14
Which modulation, which was introduced in 802.11ac standard, influences end-user experience by providing the highest data rates and throughput?

• A. 256 QAM
• B. QPSK
• C. 16 QAM
• D. 64 QAM

Answer: A

NEW QUESTION 15
An engineer is concerned about rogue-on-wire and wants to enable port security. Which guideline must the engineer follow?

• A. Configure Switched Port Analyzer destination ports as secure.
• B. Use 802 1x with port security to prevent MAC spoofing.
• C. Enable port security on dynamic access ports.
• D. Employ static MAC address configuration for APs with port securit

Answer: A

NEW QUESTION 16
A mobile workstation in a factory contains an AP that is configured as a workgroup bridge. When the workstation moves, it loses connectivity and disrupts operation. What can the engineer implement
to minimize roaming problems?

• A. Use 802.1X authentication.
• B. Use Cisco Centralized Key Management for fast roaming.
• C. Use AES for encryption.
• D. Use the mobile station comman

Answer: B

NEW QUESTION 17
Which three steps would a network engineer use to troubleshoot an AP join problem? (Choose three.)

• A. Validate the STP configuration.
• B. Verify the ping AP from the controller.
• C. Verify the ping AP from the client.
• D. Verify that the AP is getting an address from the DHCP server.
• E. I Validate the SNMP configuration.
• F. Verify the authentication configuration parameter

Answer: ABF

NEW QUESTION 18
A training class has 15 laptops connecting to the WLAN using the same Active Directory training credentials.
Users report that they cannot connect until someone else logs off. At any one time, only half of the class connect to the internet.
Which option must be checked first?

• A. Maximum Allowed Clients
• B. Client Exclusion
• C. Co-channel interference
• D. DHCP address pool

Answer: A

NEW QUESTION 19
Refer to the exhibit.

Employees upgraded company issued iOS devices, which are configured to authenticate to the
network using WPA2-Enterprise 802.1x with LEAP. As a result, the devices are no longer able to authenticate. Which action must the engineer do to resolve the issue?

• A. Redeploy the existing configuration profile.
• B. Change LEAP certificate on the ACS server.
• C. Reset the network settings on the devices.
• D. Rejoin the enterprise network manually.
• E. Deploy a new configuration profile with LEAP enabled

Answer: B

NEW QUESTION 20
Refer to the exhibit.


An access point joins the secondary wireless controller but not the primary wireless controller. Another access point has joined the controller and is working fine. The network engineer can ping the wireless controller and the access point from the core switch.
Which option is the cause of the issue?

• A. The trunk ports are missing a spanning tree configuration.
• B. The EtherChannel configuration is incorrect.
• C. The port channels configured with the wrong negotiation protocol.
• D. The trunk port configuration is incorrec

Answer: B

NEW QUESTION 21
In a high-density deployment on a customer site with ID 339696181, how do you mitigate the cell size in a large coverage area?

• A. Disable ClientLink on the WLC.
• B. Set a high supported data rate.
• C. Increase the power of the AP.
• D. Set a high mandatory

Answer: C

NEW QUESTION 22
You install a WLAN in a warehouse environment for a customer. three months after the installation, the
customer reports that the devices in the environment show a poor RSSI is some areas. Which option is a possible cause of the issue?

• A. an increase of stock in the warehouse
• B. an increase in the number of wireless clients
• C. RF interference from external sources, such as microwave ovens
• D. another WLAN installed in a neighboring warehous

Answer: A

NEW QUESTION 23
Wireless users encounter choppy VoVLAN on one floor of a building. Which troubleshooting approach will determine the cause of the issue in the least amount of time?

• A. move the problem
• B. top down
• C. shoot from the hip
• D. bottom up

Answer: A

NEW QUESTION 24
......