100% Guarantee 300-360 Dumps Questions 2021

NEW QUESTION 1
An engineer must perform a survey where the target client devices range from standard Wi-Fi-equipped laptops, consumer handhelds and tablets, and low power tracking tags limited to 12 mW Tx power. With which setting should the survey AP be configured?

• A. local power 11
• B. local power 5
• C. local power 14
• D. local power 8

Answer: B

NEW QUESTION 2
You must optimize an IPv6 wireless design to ensure that RA packets from routers can be trimmed to a minimum frequency that still maintains IPv6 client connectivity. Which configuration do you use?

• A. RA throttling
• B. AAA Override for IPv6 ACLs
• C. IPv6 ACLs
• D. RA guard

Answer: A

NEW QUESTION 3
You are designing a network deployment for a state college. The college has six buildings. Each building has a WLC located in the IDF to support access points. Which type of wireless architecture does the deployment represent?

• A. centralized
• B. distributed
• C. cloud
• D. autonomous

Answer: A

NEW QUESTION 4
If you are calibrating for 2.4 GHz and the site will not be using 802.11 and 802.11b data rates, what should be done to ensure an accurate calibration?

• A. Make sure that the access points have the unused rates disabled.
• B. Make sure that you are using an 802.11b client when calibrating.
• C. Make certain that there are no legacy clients when performing the calibration because they will disrupt the process.
• D. Make sure to use a client that supports both 802.11b/g and 802.11A.

Answer: A

NEW QUESTION 5
A customer is deploying a mesh outdoor wireless network based on FCC standards where spectrum analysis shows significant radar energy propagating throughout the coverage area from a local weather station. Which channel must be excluded from the access points RRM calculation to avoid network disruption due to weather radar activity?

• A. 132
• B. 44
• C. 11
• D. 36

Answer: A

Explanation: Weather radars operate within the 5600- to 5650-MHz band, which means that channels 124 and 128 might be affected, but also channels 120 and 132 might suffer from weather radar activity.

NEW QUESTION 6
An engineer is upgrading the legacy access points to 802.11ac Wave 2 capable access points. The existing gigabit uplinked switches provide 802.3at. Which switch limitation is a concern?

• A. collision domains
• B. high availability
• C. output power
• D. interface throughput

Answer: C

NEW QUESTION 7
Which two basic characteristics would be needed from antennas used for survey and deployment in various indoor situations? (Choose two.)

• A. Horizontally polarized
• B. Vertically polarized
• C. Aesthetically fitting
• D. Least cost
• E. Highest gain
• F. Largest beamwidth

Answer: BC

NEW QUESTION 8
An engineer is performing a predictive wireless design for a Parts Distribution Center, which requires data and location services. Which three requirements are inputs to the design? (Choose three.)

• A. access points with directional antennas
• B. continuous -67 dBm coverage from one access point
• C. overlapping -75 dBm coverage from three access points
• D. overlapping -67 dBm coverage from two access points
• E. access points in IPS mode
• F. continuous -72 dBm coverage from one access point
• G. access points in corners and along perimeters

Answer: BCG

NEW QUESTION 9
When implementing video teleconferencing over a wireless network, which three attributes should be considered when cell planning? (Choose three.)

• A. latency
• B. jitter
• C. throughput
• D. packet loss
• E. client association
• F. number of users on the network

Answer: ABD

NEW QUESTION 10
A customer is having issues streaming video over wireless in a few high-density areas of their campus. After further investigation, the administrator has singled out the issue pertains to the clients associated to 802.11b/g only access points. The rest of the campus is covered in 802.11n access points. What is a possible reason for the issue with video streaming on the 802.11b/g access points as opposed to the 802.11n access points?

• A. Due to the High-Density environment, there was high-utilization of the wireless spectru
• B. With 802.11
• C. the access points are able to aggregate the MSDU and MPDU frames into A-MSDU and A-MPDU frames, utilizing less airtime to transfer datA.
• D. The wireless clients were all transmitting at 802.11b data rates and would have operated properly had they been transmitting and receiving at 802.11g rates.
• E. The clients could not transmit data at the highest mandatory rate of 54 Mbps due to limitations with 802.11b/
• F. This data-rate is only possible when transmitting at 802.11n speeds.
• G. The wireless controller was denying the client access to the video due to multicast-direct supporting the PHY rate of 48000 that the 802.11b/g client could not handle.

Answer: A

NEW QUESTION 11
An engineer is preparing for an active site survey of a warehouse and is informed that they should not enter any areas that are blocked by supplies that are difficult to move. Which option describes how the engineer should address this restriction?

• A. Extrapolate restricted access areas by drawing circles for AP coverage
• B. Survey hallways, common areas, and storerooms.
• C. Utilize a predictive tool to define coverage in off-limits areas.
• D. Educate the customer about the importance of accurate and complete measurements.

Answer: C

NEW QUESTION 12
An engineer is deploying outdoor Cisco Aironet 1500 Series Access Points and wants to protect the network from overvoltage transients.
Which two protection methods must be used? (Choose two)

• A. lightning arrestor
• B. grounding lug
• C. antenna diversity
• D. temperature control
• E. PoE output

Answer: AB

Explanation: https://www.cisco.com/c/en/us/td/docs/wireless/access_point/1550/installation/guide/1550hig/1550_ch2.html

NEW QUESTION 13
Which three components and tasks should be considered while planning the site survey? (Choose three.)

• A. Determine the project scope, type of deployment, timeline, scale, budget, and users
• B. Determine project stakeholders
• C. Determine customer training requirements
• D. Determine AP and controller placement
• E. Determine the customer applications that the network will support
• F. Determine radio spectrum and channel allocation
• G. Schedule customer end user interviews

Answer: ABE

NEW QUESTION 14
After installation of a new data-only wireless network, an engineer found that RRM has set all of the APs to a power level of 1.
Which option describes the reason for this?

• A. APs are too far apart for the set data rates.
• B. EORRM is enabled
• C. High co-channel interference exists.
• D. DTPC value is set too high.

Answer: A

NEW QUESTION 15
Which option is the minimum RSSI signal for a data WLAN?

• A. -65 dBm
• B. -67 dBm
• C. -72 dBm
• D. -80 dBm

Answer: D

NEW QUESTION 16
A customer has a business-critical voice network and wants to be alerted whenever voice clients move out of a coverage area and experience RSSI below -67 dBm on the 5 GHz band. Which option can be configured on the wireless controller to alert network administrators when this limit is surpassed?

• A. EDCA; voice optimized
• B. SIP voice sample interval
• C. 802.11a voice RSSI coverage threshold
• D. traffic stream metrics

Answer: C

NEW QUESTION 17
Which two information points should a pre-site survey QUESTION NO:naire contain? (Choose two.)

• A. list of clients used
• B. hours during which the survey can be performed
• C. access point density required
• D. approximate square footage of facility
• E. total number of APs in use

Answer: CD

Explanation: https://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/116057-site-surveyguidel

NEW QUESTION 18
You are designing a wireless mesh network for an oil refinery. What is the Cisco-recommended model of a Cisco Aironet 1550 Series Outdoor Access Point for this location?

• A. 1552I
• B. 1552CU
• C. 1552E
• D. 1552H

Answer: D

Explanation: Cisco Aironet 1552H Access Point
This ruggedized, outdoor, 802.11n access point is suitable for generic hazardous environments, and does not require a wireless sensor network.
https://www.cisco.com/c/en/us/products/wireless/aironet-1550-series/index.html

NEW QUESTION 19
Which three recommendations must be taken into consideration when an engineer is installing a new Voice WLAN? (Choose three.)

• A. Use the Cisco wireless phone site survey client utility.
• B. Use a separate Cisco Wireless Lan Controller.
• C. Enable load balance on voice WLANs.
• D. Maintain -67dBM as a minimal RSSI.
• E. Set data for 2.4 GHz and voice for 5 GHz using separate SSIDs.
• F. Enable lower data rates for 2.4-GHz data WLAN.

Answer: ADE