Cisco 300-080 Exam Dumps 2021

NEW QUESTION 1
Refer to the exhibit. An engineer is troubleshooting a SAF client that is not registering with the SAF forwarder.

What is the root cause of the issue?

• A. The packets are being dropped on the network.
• B. The SAF password is incorrectly configured.
• C. The SAF port is incorrectly configured.
• D. The client SAF label is incorrectly configured.

Answer: A

NEW QUESTION 2
Refer to the exhibit.

A new phone was installed and currently has issues registering with Cisco Unified Communications Manager. The phone received its IP address via DHCP, with options 3 and 150.
Which two actions woulDEnable the phone to download its configuration automatically? (Choose two.)

• A. Change the phone URL parameters to IP addresses.
• B. Provide DHCP option 6 to the phone via DHCP.
• C. Reboot the phone.
• D. Change the VLAN that the phone is assigned to.
• E. Manually assign the phone settings.
• F. Provide DHCP option 15 to the phone via DHCP.

Answer: AB

NEW QUESTION 3
Cisco Unified Mobile Connect has been enabled, but users are not able to switch an in-progress call from their mobile phone to their desk phone. You find out that the Resume softkey option does not appear on the desk phone after users hang up the call on their mobile phone. What do you do to resolve this issue?

• A. Issue the progress_ind progress disable command in the gateway.
• B. Issue the voice call disc-pi-off command in the gateway.
• C. Enable mobile connect on the user profile.
• D. Assign Resume softkey on the desk phone.

Answer: B

NEW QUESTION 4
Users are reporting intermittent poor audio quality on VoIP calls. Which configuration area requires troubleshooting?

• A. network QoS
• B. media resource
• C. call routing
• D. phone setup

Answer: A

NEW QUESTION 5
You observe that EMCC restriction on the cluster fails when a user with a different profile logs in to another cluster. Which action can you take to correct the problem?

• A. Enable logical partitioning.
• B. Set SIP session timers to 0.
• C. Set SIP session timers to 3800.
• D. Configure the regions in Cisco Unified Communications Manager to allow EMCC.

Answer: D

NEW QUESTION 6
Refer to the exhibit.

Media Termination Point is required when the H.264 codec-capable video endpoints route calls via a specific Cisco Unified Communications Manager SIP trunk, in order to provide DTMF interworking capabilities. In the exhibit, a designated IOS Software MTP is configured. However, calls establish as audio only when using this particular MTP. Which codec is missing from this IOS MTP configuration?

• A. codec pass-through
• B. codec h264 cif
• C. codec h263 cif
• D. codec h264 720p

Answer: A

NEW QUESTION 7
Refer to the exhibit.

ACUCM user has been configured to use the Mobility feature and is expecting their home phone
408-555-6016 to ring simultaneously when their office phone is called. What configuration change needs to be made to allow this happen?

• A. Select the Enable Move to Mobile check box.
• B. Select the Enable Extend and Connect check box.
• C. Select the Line Association check box.
• D. Deselect the Enable Single Number Reach check box.

Answer: C

NEW QUESTION 8
Refer to the exhibit.

Cisco Unified Communication Manager has been configured with a SAF Security Profile and a SAF Forwarder. In which section of the R1 router configuration should the SAF Forwarder password be entered?

• A. interface loopback 0
• B. router eigrp saf
• C. service-family external client
• D. service-family ipv4

Answer: C

NEW QUESTION 9
You need to add transcoding support for g711alaw between two different sites. The current configuration is as follows:
dspfarm profile 1 transcode codec g711 ulaw
codec g729ar8 codec g729abr8 codec g729br8 codec g729r8 maximum sessions 4
associate application SCCP
Which two steps do you need to take in order to add support for this codec? (Choose two)

• A. Issue the command no associate application SCCP.
• B. Issue the command shutdown under the dspfarm profile.
• C. Add the command codec g711alaw and issue the no shutdown command.
• D. Disassociate the profile under the CCM group.
• E. Add the command codec g711alaw and issue the command no sccp followed by the command sccp.

Answer: CE

NEW QUESTION 10
Which set ensures that all SAF clients receive all service advertisements?
A)

B)

C)

D)

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: C

NEW QUESTION 11
Refer to the exhibit.

You're tasked with staging configuration changes to add conference bridge functionality to an existing IOS voice gateway deployment. What command is missing for the configuration to be accepted by the IOS CLI?

• A. The command maximum conference-participants must be configured under the dspfarm profile.
• B. The Enhanced IOS Conference Bridge is not configured in Cisco Unified Communications Manager.
• C. The command dsp services dspfarm must be configured under the voice-card configuration.
• D. The dspfarm command under the voice card is missing.
• E. The dsp tdm pooling command under the voice-card is missing.

Answer: C

NEW QUESTION 12
In Cisco Unified Communications Manager (CUCM), the primary Service Advertisement Framework (SAF) forwarder is deleted from the database.
If there were total of three SAF forwarders configured, which two will happen next? (Choose two.)

• A. The backup SAF forwarder will automatically become the primary SAF forwarder.
• B. The third SAF forwarder will become the primary SAF forwarder.
• C. The third SAF forwarder will become the backup SAF forwarder.
• D. You need to desinate the backup SAF forwarder as the primary SAF forwarder.
• E. Through an election, the backup and the third SAF forwarder will be designated as primary SAF forwarder.
• F. CUCM will wait for the primary SAF forwarder to come alive.

Answer: AC

NEW QUESTION 13
Which issue would cause an MGCP gateway to fail to register with Cisco Unified Communications Manager?

• A. missing the configuration command isdn bind-l3 ccm-manager under the ISDN interface
• B. mismatched domain name on the MGCP gateway and Cisco Unified Communications Manager gatewayconfiguration
• C. misconfigured route group in Cisco Unified Communications Manager
• D. incorrect MGCP IP address specified in the gateway configuration in Cisco Unified Communications Manager

Answer: B

NEW QUESTION 14
Refer to the exhibit.

Which course of action will resolve the Mobile Connect issues that are shown in the exhibit?

• A. Configure the Mobility softkey on the phone.
• B. Enable the user for Cisco Mobile Connect.
• C. Make the user an owner of the phone device in the phone device configuration page.
• D. Enable the device mobility mode on the phone since it is disabled.

Answer: C

NEW QUESTION 15
Which Cisco Unified Communications Manager tool verifies configured route patterns, calling search spaces, and route groups?

• A. Cisco Unified Reporting
• B. Cisco Unified Communications Manager CDR Analysis and Reporting
• C. Cisco Unified Communications Manager Dialed Number Analyzer
• D. Cisco Unified Real-Time Monitoring Tool

Answer: C

NEW QUESTION 16
An endpoint cannot connect to a valid TFTP server during the registration process. Which two statements describe possible causes? (Choose two.)

• A. The DHCP configuration contains TFTP server 66, but no DNS server is available.
• B. The DHCP configuration contains TFTP server 150, but no DNS server is available.
• C. No separate voice VLAN configuration on the switch port connected to the endpoint.
• D. Cisco Unified Communications Manager CallManager services are not started.
• E. Cisco Unified Communications Manager TFTP services are not started.

Answer: DE

NEW QUESTION 17
An engineer encounters an issue where ACustomer wants to enable multiple Cisco Telepresence conference bridges, but can enable only one. Which option is the cause of this issue?

• A. No valid release key is installed on the TS Conductor.
• B. TS Conductor can support only one conference bridge.
• C. Conference bridge in Cisco Unified Communications Manager under Diagnostics > Conference Bridge is not enabled.
• D. All conference bridges are not added in media resources under MRG in Cisco Unified Communications Manager.

Answer: D

NEW QUESTION 18
Where do you configure the phone book provisioning synchronization for an endpoint that is reentered to Cisco VCS?

• A. in Cisco Unified Communications Manager, under the SIP trunk to Cisco VCS
• B. on the Cisco Express C
• C. in the Cisco TelePresence Management suite in the Cisco VCS configuration
• D. on the Cisco VCS Expressway
• E. on the Cisco VCS Control
• F. in the Cisco TelePresence Management Suite under Administration > Provisioning

Answer: F