How Many Questions Of 201 Free Question

NEW QUESTION 1
The current status of a given pool is offline (red). Which condition could explain that state? Assume the descriptions below include all monitors assigned for each scenario.

• A. No monitors are currently assigned to any pool, member or node.
• B. The pool has a monitor assigned to it, and none of the pool members passed the test.
• C. The pool has a monitor assigned to it, and only some of the pool's members passed the test.
• D. A monitor is assigned to all nodes and all nodes have passed the tes
• E. The pool's members have no specific monitor assigned to them.

Answer: B

NEW QUESTION 2
A BIG-IP Administrator remotely connects to the appliance via out-of-band management using https://mybigip mycompany net. The management portal has been working all week. When the administrator attempts to login today, the connection times out. Which two aspects should the administrator verify? (Choose two)

• A. DNS is property resolving the FQDN of the device.
• B. The device is NOT redirecting them to http.
• C. The administrator has the latest version of the web browser.
• D. Packet Filters on the device are blocking port 80.
• E. The administrator has TCP connectivity to the device.

Answer: AE

NEW QUESTION 3
A BIG-IP Administrator need to ensure that a pool member and down by the monitor the BIG-IP system sends existing connections to another be pool member.
Which should the BIG-IP Administrator perform to meet this goal?

• A. Set Action on Service Down sing under the server configuration to reselect.
• B. Reconfigure the pool motor members as UP.
• C. Enable mirroring within the persistence profile.
• D. Set Action Service Down setting under the pool configuration to reselect.

Answer: D

NEW QUESTION 4
Refer to the exhibit.

An LTM device has a virtual server mapped to www.f5.com. Users report that when they connect to
/resources/201.1.2h.l_l.com they are unable to receive content. What is the likely cause of the issue?

• A. The pool associated with the virtual server does not have priority group activation enabled.
• B. The virtual address does not have ARP enabled.
• C. The virtual address does not have route advertising enabled.
• D. The pool associated with the virtual server is falling its health check.

Answer: B

NEW QUESTION 5
A site is load balancing to a pool of web servers. Which statement is true concerning BIG IP's ability to verify whether the web servers are functioning properly or not?

• A. Web server monitors can test the content of any page on the server.
• B. Web server monitors always verify the contents of the index.html page.
• C. Web server monitors can test whether the server's address is reachable, but cannot test a page's content.
• D. Web server monitors can test the content of static web pages, but cannot test pages that would require the web server to dynamically build content.

Answer: A

NEW QUESTION 6
A site has assigned the ICMP monitor to all nodes and a custom monitor, based on the HTTP template, to a pool of web servers. The HTTP based monitor is working in all cases. The ICMP monitor is failing for 2 of the pool member 5 nodes. All other settings are default. What is the status of the monitor is working in all cases?

• A. All pool members are up since the HTTPbased monitor is successful.
• B. All pool members are down since the ICMPbased monitor is failing in some cases.
• C. The pool members whose nodes are failing the ICMPbased monitor will be marked disabled.
• D. The pool members whose nodes are failing the ICMPbased monitor will be marked unavailable.

Answer: D

NEW QUESTION 7
Which two statements are true about SNATs? (Choose two.)

• A. SNATs are enabled on all VLANs, by default.
• B. SNATs can be configured within a Profile definition.
• C. SNATs can be configured within a Virtual Server definition.
• D. SNAT's are enabled only on the VLAN where origin traffic arrives, by default.

Answer: AC

NEW QUESTION 8
A BIG-IP Administrator uses a device group to share the workload and needs to perform service on a BIG-IP device currently active for a traffic group. The administrator needs to enable the traffic group to run on another BIG-IP device in the device group. What should the administrator do to meet the requirement?

• A. Create a new Traffic Group and then fail to Standby Unit
• B. Select Traffic Group and then select Failover
• C. Select Traffic Group and then select Force to Standby
• D. Select Traffic Group on Primary Unit and then select Demote

Answer: C

NEW QUESTION 9
A BIG-IP Administrator needs to modify a virtual server that web offload web traffic compression tasks from the target server.
Which two profiles must the BIG-IP Administrator apply to a virtual server to enable compression? (Choose two)

• A. Server SSL profile
• B. Stream profile
• C. Persistence profile
• D. HITP profile
• E. Compression profile

Answer: DE

NEW QUESTION 10
Which parameters are set to the same value when a pair of BIG-IP devices are synchronized?

• A. host names
• B. system clocks
• C. profile definitions
• D. VLAN failsafe settings
• E. MAC masquerade addresses

Answer: C

NEW QUESTION 11
Generally speaking, should the monitor templates be used as production monitors or should they be customized prior to use.

• A. Most templates, such as http and tcp, are as effective as customized monitors.
• B. Monitor template customization is only a matter of preference, not an issue of effectiveness or performance.
• C. Most templates, such as https, should have the receive rule customized to make the monitor more robust.
• D. While some templates, such as ftp, must be customized, those that can be used without modification are not improved by specific changes.

Answer: C

NEW QUESTION 12
A BIG-IP system has the following configuration:
* SNAT is set to Auto Map
* There are two VLANs internal and external
* Default route is pointed to the gateway on external VLAN
* Self P for internal VLAN is 1921.1.2
* Self IP for external VLAN is 192.1.2.2
* Floating IP addresses for internal VLAN is 192.1.1.1
* Floating IP addresses for external VLAN is 192.1.2.1
* The Virtual Server IP address is 192.1.1.100
Which IP address does the BIG-IP system use first when traffic reaches the servers on the internal VLAN?

• A. 192.1.1.100
• B. 192.1.2.2
• C. 192.1.1.1
• D. 192.1.2.1

Answer: C

NEW QUESTION 13
The BIG-IP Administrator needs to perform a BIG-IP device upgrade to the latest version of TMOS. Where can the administrator obtain F5 documentation on upgrade requirements?

• A. iHealth
• B. Network > Interfaces
• C. Local Traffic > Pools
• D. AsKFS
• E. Local Traffic > Virtual Servers

Answer: C

NEW QUESTION 14
A BIG-IP Administrator finds the following log entry after a report of user issues connecting to a virtual server: 01010201: 2: Inet port exhaustion on 10.70.110.112 to 192.28.123.250:80 (proto 6)
How should the BIG-IP Administrator modify the SNAT pool that is associated with the virtual server?

• A. Remove the SNAT pool and apply SNAT Automap.
• B. Remove an IP address from the SNAT pool.
• C. Add an address to the SNAT pool.
• D. Increase the timeout of the SNAT addresses.

Answer: C

NEW QUESTION 15
Which statement is true concerning the default communication between a redundant pair of BIG-IP devices?

• A. Communication between the systems cannot be effected by port lockdown settings.
• B. Data for both connection and persistence mirroring are shared through the same TCP connection.
• C. Regardless of the configuration, some data is communicated between the systems at regular intervals.
• D. Connection mirroring data is shared through the serial fail over cable unless network failover is enabled.

Answer: B

NEW QUESTION 16
A BIG-IP Administrator is working with a BIG-IP device and discovers that one of the Interfaces on a Trunk is DOWN.
What is the reason for this Interface status?

• A. The switch is NOT connected to the Interface
• B. There is NO transceiver installed on the Interface
• C. There is NO default route configured for this trunk
• D. The media speed of the interface has NOT been set

Answer: A

NEW QUESTION 17
......