Cisco 200-355 Braindumps 2021

NEW QUESTION 1
What is the maximum number of access points supported on Cisco WCS with an enterprise license?

• A. 5,000
• B. 10,000
• C. 50,000
• D. 100,000

Answer: C

NEW QUESTION 2
An access point named Cisco AP is configured on a wireless controller. Which command must you use in the controller to view access point system messages?

• A. show ap eventlog Cisco_AP
• B. debug ap eventlog Cisco_AP
• C. config logging Cisco_AP
• D. show logging

Answer: A

NEW QUESTION 3
A customer is converting from a Flex Connect solution to a converged access solution at a remote facility. The facility currently supports 500 users with 45 access points, so he is planning to install only one switch What switch would need to be implemented to support the new converged access methodology'?

• A. Cisco 3850 Series Switch
• B. Cisco 6800 Series Switch
• C. Cisco 3650 Series Switch
• D. Cisco 4500 Series Switch

Answer: A

Explanation: http://ccnawirelesswannabe.blogspot.com/2021/08/configuring-cisco-36503850-wireless.html

NEW QUESTION 4
Which two actions would you use to begin to troubleshoot an access point that fails to join a wireless LAN
controller successfully? (Choose two.)

• A. SSH to the AP.
• B. SSH to the Cisco WCS.
• C. SSH to the Cisco WLC.
• D. Issue the Cisco WLC command debug capwap events enable
• E. Issue the Cisco WLC command show capwap events

Answer: CD

NEW QUESTION 5
On an autonomous access point, to which interface do you assign the IP address so that the GUI configuration tool can be used?

• A. BVI1
• B. DotHRadio0
• C. GigabitEthernet0
• D. FastEthernet0

Answer: A

NEW QUESTION 6
What regulatory body approves a Wi-Fi device before it can be sold in the US?

• A. FCC O
• B. ITU-R
• C. IEEE
• D. WiFi-Alliance

Answer: A

NEW QUESTION 7
Which is recommended minimum SNR for a data cell with a data rate of 54 Mb/s?

• A. 10
• B. 25
• C. 4
• D. 6

Answer: B

NEW QUESTION 8
While undergoing a security audit, a network administrator is told to set up the WLANs with at least 128-bit encryption but also keeping the 802.11n speeds. What WLAN configuration would meet the requirements?

• A. Static WEP
• B. WPA-TKIP
• C. WPA2-AES
• D. CKIP

Answer: C

NEW QUESTION 9
A company wants to implement wireless in all 20 remote office locations and wants centralized management of these remote sites. What application would meet the requirements?

• A. Control And Provisioning of Wireless Access Points
• B. Cisco point- to multi-point wireless bridging
• C. Cisco autonomous access points in FlexConnect mode
• D. Split MAC architecture utilizing LWAPP and WLC

Answer: D

NEW QUESTION 10
What two access methods are enabled by default on a Cisco WLC? (Choose two.)

• A. HTTP
• B. HTTPS
• C. Telnet
• D. SSH
• E. VPN
• F. SFTP

Answer: BD

NEW QUESTION 11
Which two factors must be considered when evaluating an RF interferer for severity? (Choose two.)

• A. distance from the AP
• B. dBm
• C. the type of security crack being used
• D. duty cycle
• E. number of interfering IP stations in the cell
• F. duplicate SSID

Answer: BD

NEW QUESTION 12
What is derived from measuring the RF duty cycle?

• A. dynamic channel selection
• B. LWAPP header length
• C. RF utilization
• D. transmit power control

Answer: C

NEW QUESTION 13
Refer to the exhibit.

A company added a Cisco Wireless LAN Controller to the network and converted all APs to lightweight APs. What is the hop order of the data packets when traveling from Client A to Client B. if the APs are local mode?

• A. Monitor
• B. Local
• C. FlexConnect
• D. SE-Connect

Answer: C

NEW QUESTION 14




The AP is unable to join the WLC. What switch configuration will correct this problem?

• A. interface vlanlip helper-address 10.10.10.10
• B. interface vlan20ip helper-address 10.10.10.10
• C. ipdhcp pool vlanloption 43 ascii '10.10.10.10'
• D. ip dhcp pool vlan20option 43 ascii '10.10.10.10'
• E. ipdhcp pool vlanloption 43 hex f1040a0a0a0a
• F. ip dhcp pool vlan20option 43 hex f1040a0a0a0a

Answer: F

NEW QUESTION 15
You are configuring an IP address on an autonomous access point. Which interface do you use to configure the IP address?

• A. BVI1
• B. FastEthernet 0
• C. Dot11Radio0
• D. VLAN 1

Answer: A

NEW QUESTION 16
Which CAPWAP AP management-access method is available as the default setting?

• A. only the console port
• B. the console port and SSH
• C. the console port, SSH, and HTTPS
• D. SSH only

Answer: A

NEW QUESTION 17
You are testing a new autonomous Cisco Aironet 1260 AP that has booted for the first time on the existing corporate network, which includes voice, data, and location services.
How do you reach the GUI of the AP?

• A. HTTP to 10.0.0.1.
• B. HTTP to 192.168.1.1.
• C. HTTP to the DHCP address.
• D. HTTPS to 10.0.0.1.
• E. HTTPS to the 192.168.1.1.
• F. HTTPS to the DHCP address.

Answer: C