Highest Quality H12-211 Dumps 2021

NEW QUESTION 1
<Huawei> system-view
[Huawei]command-privilege level 3 view user save
Refer to the command output. What is the result of the shown command?

• A. The command adjusts the save command of a user to privilege level 3.
• B. The command adjusts the save command in the user view to privilege level 3.
• C. The command adjusts the user view command privilege level to 3, and saves the configuration.
• D. The command adjusts the privilege level of a user to 3, and saves the configuration.

Answer: B

NEW QUESTION 2
10.0.1.0/24 O_ASE 150 2 D 10.0.23.3 Serial2/0/0
Refer to the display output. Which of the following statements regarding route shown are true?(Choose two)

• A. The address 10.0.23.3 has been configured on the peer’s serial 2/0/0 interface.
• B. The route preference has been changed by the adminstrator.
• C. The metric for the route 10.0.1.0 indicates that two hops are needed.
• D. The route has been learned via the OSPF protocol.

Answer: AD

NEW QUESTION 3
An administrator currently manages AR2200 devices in the network through a single password, however thecompany wishes to introduce another two administrators and provide unique user credentials and privilegelevels for telnet access to the network devices. What action can be taken?(Choose three)

• A. Configure three users under the AAA-view, and assign each a different password.
• B. The authentication mode must be changed to AAA.
• C. Each administrator must be assigned a privilege level.
• D. A public IP address must be assigned to each user for telnet access

Answer: ABC

NEW QUESTION 4
An authenticator router has been configured with two domains named “Area1” and “Area2”, following which auser is created with the username “huawei” and the password ”hello” for authentication. Which domain doesthis user belongs to?
<choice ident=“A”>
<choice ident=“B”>
<choice ident=“C”>
<choice ident=“D”>

• A. Area1 domain
• B. Area2 domain
• C. default domain
• D. default_admin domain

Answer: C

NEW QUESTION 5
An administrator discovered he/she was unable to use TFTP to transfer files to the router.
Which of thefollowing describes the likely reason for this?

• A. The TFTP service had been disabled on the router.
• B. TCP port 69 of the server had been blocked.
• C. UDP port 69 of the server had been blocked.
• D. The username and password had been modified.

Answer: C

NEW QUESTION 6
To establish multiple PPP point-to-point connections in the Ethernet network, a PPPoE server establishesconnections with multiple PPPoE clients on one Ethernet port. How does PPPoE differentiate between eachconnection?

• A. MAC address.
• B. IP address and MAC address
• C. MAC address and ppp-id
• D. MAC address and session-id

Answer: D

NEW QUESTION 7
Which of the following statements regarding the router ID in OSPF are incorrect?(Choose three)

• A. The router IDs of OSPF routers in the same area must be the same, but can be different in different areas.
• B. The router ID must be the IP address of an OSPF router interface.
• C. The router ID must be configured manually.
• D. A router running OSPF must have a router ID for it to operate properly.

Answer: ABC

NEW QUESTION 8
The administrator wishes to manage a network through telnet from a user's terminal to a
router. How can thisbe achieved?

• A. A connection should be established between the ethernet port of the terminal and the console port of therouter.
• B. A connection should be established between the ethernet port of the terminal and the ethernet port of therouter.
• C. A connection should be established between the console port of the terminal and the ethernet port of therouter.use console cable connect pc’s ethernet port and router’s console port.
• D. A connection should be established between the COM port of the terminal and the console port of therouter.

Answer: B

NEW QUESTION 9
UDP is connectionless oriented, which of the following must be used in order to ensure reliability?

• A. Internet Protocol
• B. Application Layer Protocol
• C. Network Layer Protocol
• D. Transmission Control Protocol

Answer: B

NEW QUESTION 10
[RTA]acl 2002
[RTA-acl-basic-2002]rule permit source 20.1.1.1 0
[RTA-acl-basic-2002]rule permit source 30.1.1.1 0
Refer to the configuration output. A network administrator configured the ACL on router
RTA, as shown. Whichof the following statements regarding the rule order are correct?(Choose two).

• A. The rule-number of the first rule is 1
• B. The rule-number of the first rule is 5
• C. The rule-number of the second rule is 2
• D. The rule-number of the second rule is 10

Answer: BD

NEW QUESTION 11
Destination/Mask protocol pre Cost Nexthop Interface
9.0.0.0/8 OSPF 10 50 1.1.1.1 Serial 1/0/0
9.1.0.0/16 RIP 100 5 2.2.2.2 Ethernet 0/0/1
Refer to the graphic. Which of the following statements is correct when this router forwards the packet to thedestination host 9.1.4.5?

• A. The router selects the first entry to match the destination address of the packet because the preference ofOSPF is higher than the preference of RIP.
• B. The router selects the second entry to match the destination address of the packet because the cost of RIPis lower than that of OSPF.
• C. The router selects the second entry to match the destination address of the packetbecause the outgoinginterface is an Ethernet interfac
• D. The forwarding speed of an Ethernet interface is faster than theforwarding speed of a serial interface
• E. The router selects the second entry to match the destination address of the packet because the router willmatch the most specific address.

Answer: D

NEW QUESTION 12
Which of the following types can ICMP packets be classified into?(Choose two)

• A. ICMP transport packet
• B. ICMP error reporting packet
• C. ICMP query packet
• D. ICMP application packet

Answer: BC

NEW QUESTION 13
Two routers are configured with OSPFv3. OSPFv3 is enabled on all interfaces of each router. Which of thefollowing is true in the event that the network administrator does not configure a Router-ID?

• A. The IP address of the loopback 0 interface will be used as the router ID
• B. The IP address of the loopback 1 interface will be used as the router ID
• C. The IP address of interface G0/0/0 will be used as the router ID
• D. No router ID will be assigned to the router.

Answer: D

NEW QUESTION 14
An end system is unable to communicate with a DHCP server following the startup process. Which IP addressmay be used by the client?

• A. 0.0.0.0
• B. 127.0.0.1
• C. 169.254.2.33
• D. 255.255.255.255

Answer: C

NEW QUESTION 15
NAPT uses the same public address but different port numbers to translate private addresses. Whichstatement regarding the port number is correct?

• A. It is necessary to configure port number mapping manually.
• B. It is only necessary to configure the port number range.
• C. It is not necessary to configure port numbers.
• D. An access control list is needed to assign port numbers.

Answer: C

NEW QUESTION 16
What will the destination MAC address be at the moment a frame is transmitted by the host, when the router isthe IP destination?

• A. The MAC address of the switch.
• B. The MAC address of the router interface G0/0/0.
• C. The MAC address of the host.
• D. The destination MAC address will be a broadcast MAC address.

Answer: D

NEW QUESTION 17
The administrator wishes to change name of the router. Under which view should the administrator be in orderto achieve this?

• A. User-view
• B. System-view
• C. Interface-view
• D. Protocol-view

Answer: B

NEW QUESTION 18
Two routers have established a point-to-point network using PPP. The administrator has configured the routersto run OSPF in the same area with the same router ID, what will behavior will occur as a result of theconfiguration?

• A. The routers will build a neighbor relationship even though both routers are using the same router ID.
• B. VRP will notify of a router ID conflict between the two routers.
• C. The routers will build an adjacency even though both routers are using the same router ID.
• D. The routers will not send hello packets to each other because they are using the same router ID.

Answer: B